Hydrashovel wrote:skal det ikke settes inn med olje også?
Nei.
Fra service-manualen (står også det samme i brukermanualen):
6. Clean filter element.
a. Wash the paper/wire mesh air filter element and
breather tubes in lukewarm water with a mild detergent.
Do not strike filter element on a hard surface to
dislodge dirt.
b. Allow filter to either air dry or blow it dry, from the
inside, with low pressure air.
Do NOT use air cleaner
filter oil on the Harley-Davidson paper/wire mesh air
filter element.
c. Hold the filter element up to a strong light source. If
light is uniformly visible through the element, it is
sufficiently clean.
Og for SE-filteret:
MAINTENANCE
Air Cleaner Element Maintenance
NOTES
This is a dry air filter. Do not apply oil to the filter element.
When servicing the air cleaner, apply Loctite 243 (blue) to
threads of all fasteners.
1. See Figure 1. Remove air cleaner cover (B) and inspect
the filter element (7) every 5000 mi (8000 km), or more
often under dusty conditions.
2. Clean filter element as follows:
a. Remove and wash element by immersing it, on edge,
in a shallow pan containing enough Air
Cleaner/Degreaser to cover no more than 3/4 the
depth of the filter pleats. Do not let dirty solution get
inside the element. Carefully "roll" the element in the
solution around its perimeter until the entire outer
surface of the filter pleats has been soaked.
b. Remove filter element from cleaner/degreaser and
allow five minutes for the cleaner to dissolve the dirt.
c. From the inside out, rinse the element with cold water.
Shake off excess water, and allow the element to air
dry. Do not dry with compressed air.
3. Install air cleaner element and cover